If you don t have a vinyl cutting blade you can use another fine toothed blade.
Cutting vinyl lattice circular saw.
Always use cutting blades which are sharp enough.
Start by cutting your vinyl lattice.
Position the circular saw blade at one end of the lattice sheet lining up the blade with the marked cutting line.
Mark the area to cut and slowly feed the blade into the siding.
I had to replace a couple vinyl lattice sections that w.
Install a plywood blade backward onto a circular saw.
For plastic or solid core vinyl lattice you may want to use a vinyl cutting blade.
Cutting pvc creates sharp saw shavings vinyl lattice is used for a number of things from arbors fence accents and deck or porch skirts.
Cut through the lattice joint by joint using a circular saw with a vinyl cutting blade.
It also enables you to cut accurately and effectively.
These include miter saws chop saws table saws and handheld circular saws.
You will find a special type of cutting blade specifically made to cut vinyl lattice.
You should never go for a saw blade with large teeth capable of ripping and tearing.
This is the easiest way to cut vinyl lattice that i ve come across and i wanted to share it with you.
It is best to attach a carbide tipped wood blade to the power saw for a wooden lattice.
The best tool for cutting plastic lattice is a circular saw with a plastic cutting blade.
It comes in a variety of designs but a diagonal weave is among the more traditional choices.
To cut the vinyl lattice you will need a circular saw and a cutting blade.
8 squeeze the saw s trigger and make a slow steady cut down the line.
Position the saw so it s right along the pencil line then start making a careful straight cut down the lattice.
Squeeze the saw s trigger and move the circular saw slowly along the full length of the marked line.
Ease the saw or blade carefully through the lattice.
The best saw blade for cutting vinyl lattice is one that has small straight teeth not teeth that are hooked or otherwise designed to rip and tear such as saw blades designed to cut through.
If necessary walk on the lattice to the side of the lumber opposite the saw and marked line.
If you use a dull blade it will not provide you a good finished result.
Use a power saw such as a circular saw or fine toothed hard saw to cut the panels to size.
